Tips to Photographing Your Trophy Fish With catch and release fishing, the ultimate goal is to return the fish to the water quickly and gently. Touch the fish as little as possible and never touch the gills. Because you have so little time, be sure the person taking the picture is ready to go. That means the film is in the camera, the cap is off the lens and the photographer is holding the camera up to his or her eye ready to snap as you are landing that trophy! When you are in the boat, sometimes it can be tricky but try to keep the camera even with the horizon of the water. It can be distracting if the horizon is on an odd angle. Keep the picture as uncluttered as possible. The water, sky and distinct beauty of the tundra around Tukto Lodge are background enough!

Care And Repair Of Fishing Lures Fishing lures that have feathers or hair should be kept in airtight containers so that moths and other insects or small animals will not get to them. This also applies to new fishing lures that haven't yet been used. Lures which have been used require considerable care if you want to get the maximum use from them. Freshwater fishing lures usually require less care and repair than saltwater ones. In general, when examining any fishing lure you have made or bought it's a wise policy to repair it if you are the least bit doubtful about its condition. Repairing usually means sandpapering the part of the lure body that is slightly chipped and then touching up with a small brush, using enamels or lacquers.

A Guide to Non-Typical Catfish Fishing Techniques Part II Catching Them Typically, when I set up to fish these ledges, I run my boat over them and throw out my marker buoy where I see the fish. A little trick to using your marker buoys is to throw your marker upwind of where you are going to fish. If you drop the marker right on top of the fish, you will be bumping it and will eventually move it while the wind is pushing you around. If you throw it upwind of the fish, you can run your trolling motor right up to it without the wind pushing you over it. Next I bait my rods, staggering them at the depth I see the fish. If the fish are up high, above 10 feet, I use a balloon and live shad on two rods. The other four rods will have half live and half cut shad, which I will suspend over the fish, continuously moving around the marker until the first strike occurs. In the warmer months the bite will usually occur on live shad. The colder the water, the better that cut bait seems to work.

Worm Rigs - Fishing Plastic Worm Rigs - How to Fish Worm Rigs
If you use plastic worms you know there are many ways to rig them. Sometimes the conditions dictate how you rig them up, other times the fish just seem....